Chapter 6 Sweep
In sweep mode, the instrument outputs the waveform that changes from the start frequency to the
stop frequency at a specified sweep rate.HDG3000B(C) supports linear sweep mode.
Users can configure the instrument to output one sweep from start frequency to stop frequency by
applying an external or manual trigger. The instrument can sweep sine, square, pulse, ramp,
Harmonic or arbitrary waveforms (expect DC).
Select Sweep
Start Frequency and Stop Frequency
Center Frequency and Frequency Span
Linear Sweep
Sweep Time
Return Time
Hold Time
Mark Frequency
Sweep Trigger Source
Trigger Output Edge
User Manual 55
To Next Page
Loading...
