Hantek HDM3000 - Page 15

12
Aperture PLC: 0.02, 0.2, 1, 10, 100. Default value: 10
Auto Zero: Off or On (default)
Keys
Application
Configure 4 wire resistance measurement.
Range: 100 Ω, 1 kΩ, 10 kΩ, 100 kΩ, 1 MΩ, 10 MΩ or 100 MΩ.
Note: The approximate current sourced for each range (for example, ~1mA) is shown on
each range softkey.
Aperture PLC: 0.02, 0.2, 1, 10, 100. Default value: 10
Configure frequency and period measurements. Parameters include
range, AC filter, and gate time.
Range: 100 mV, 1 V, 10 V, 100 V, 750 V, Auto (default)
AC Filter: >3 Hz, >20 Hz, >200 Hz
Gating time: 10 ms, 100 ms(default) or 1 s
Timeout: 1 s(default) or Auto
Configure capacitance measurement:
Range: 1 nF, 10 nF, 100 nF, 1µF, 10µF, 100µF or Auto (default)
Configure continuity measurement:
Beeper: Close or On (default)
Configure diode measurement:
Beeper: Close or On (default)
Configure 2-wire and 4-wire temperature measurements.
Probe types: RTD2W, RTD4W (default), Thermis2W, Thermis4W