53
Display - Introduction
By default, the instrument displays the reading in digital form. You can also select bar
meter, trend chart or histogram display:
For "digital" and "bar meter" displays, many of the main measurement functions allow
the display of auxiliary measurement results.
Select Display
Press the Key, and then press the Display soft key to select the Display
type:
The table below summarizes all display types for each measurement mode.
meter
histogram
by default
when
booting.
Display the
Bar chart.
Display the
measured
results on
spanning a specified
length of time.
Displays as a bar chart
(trend
the histogram
data only.
There is no
readings on the
front panel.
To Next Page
Loading...