7
INPUT
Input
Sampling cycle time
Input resolution
Input impedance
Allowable signal source
resistance
Allowable wiring
resistance
Allowable input voltage
Noise ratio
Standard
Standard junction
temperature
compensation tolerance
Burn-out detection
Accuracy
Thermocouple, R.T.D, Direct voltage
( refer to the input signal and measurement range on page 18 )
250 mS
Below decimal point of range
Thermocouple / Voltage (mV) input : 1
or above
Voltage input ( V ) : Approx. 1
Thermocouple : 250 or below
Voltage input : 2
or below
R.T.D : 150
or below / 1 wire
Thermocouple, R.T.D, Direct voltage (mV) :
10 V
Direct voltage (V) :
20 V
NMRR :40 dB or above
CMRR :120 dB or above ( 50/60 Hz
1 %)
Thermocouple / R.T.D ( KS / IEC / DIN )
1.5 ( 15 ~ 35 ), 2.0 ( 15 ~ 50 )
OFF, Up / Down scale selectable
Thermocouple burn-out : Up / Down scale
R.T.D burn-out : Up scale
(TC / R.T.D burn-out detection current : Approx. 50
)
0.1 % of F.S
SPECIFICATION
4
100 - 240 V ~, 24 V
50/60 Hz
-10 % +10 %
Max. 6.0 W, 10 VA or below
27 V - 20 mA ( but, it is not available when using retransmission output )
20
min. (at 500 V DC)
Between primary terminal and secondary terminal
Between primary terminal and ground
Between ground and secondary terminal
2300 V AC 50/60 Hz for 1 minute
Between primary terminal and secondary terminal
Between primary terminal and ground
Between F.G and secondary terminal : 1500 V AC 50/60 Hz for 1 minute
Power supply voltage
Frequency
Voltage variation
Power consumption
Power supply for
sensor
Insulation resistance
Dielectric strength
POWER SUPPLY
To Next Page
Loading...
Need help?
General
