Need help?Do you have a question about the Haojue NK150 2020 and is the answer not in the manual?
Guidance on safely installing and loading accessories to prevent unsafe operating conditions.
Emphasizes the importance of wearing a properly approved helmet for safety.
Advises choosing high-quality, well-fitting clothing for riding.
Recommends thoroughly reviewing pre-ride inspection instructions for safety.
Suggests practicing in a non-traffic situation to learn controls.
Advises riding within personal skill limits to avoid accidents.
Advises extra caution on wet or slippery roads, railway crossings, etc.
Warns against riding at excessive speeds or high engine speeds.
Identifies and illustrates various control and part locations on the motorcycle.
Indicates the fuel level on the dashboard display.
Illuminates when the motorcycle is in neutral gear.
Lights up when the high beam headlight is activated.
Reminds the rider to change the engine oil based on mileage.
Flashes when the right turn signal switch is activated.
Used for adjusting display settings, particularly the oil change indicator.
Displays the riding speed in kilometers per hour.
Features a clock that can be adjusted and used as a timer.
Records total distance and distance for shorter rides or fuel calculations.
Shows the current gear the motorcycle is in.
Displays engine revolutions per minute (RPM).
Indicates the current fuel level in the tank.
Used to switch between total and trip meters, and for oil change indicator reset.
Alerts the rider to potential battery discharge or recharge needs.
Controls the headlight's low beam and high beam settings.
Activates the headlight flash for overtaking.
Engages/disengages the clutch for starting or shifting gears.
Activates the motorcycle's horn.
Controls the left and right turn signals.
Initiates the engine's electric starter motor.
Controls engine speed by adjusting throttle opening.
Applies the front wheel brake when grasped.
Aids in starting a cold engine by enriching the fuel mixture.
Controls the flow of fuel from the tank to the carburetor.
Operates the motorcycle's 5-speed transmission.
Information regarding the rear suspension unit and safety warnings.
Activates the rear wheel drum brake.
Provides an alternative method for starting the engine.
Location and access to the motorcycle's onboard tool kit.
Instructions for using the side stand for parking and safety.
Guide for checking the side stand rubber block for wear or malfunction.
Details the load capacity and safety considerations for the rear carrier.
Specifies the recommended octane rating for gasoline.
Guidelines for selecting and using quality engine oil for performance and longevity.
Advises on maximum throttle opening during the break-in period.
Emphasizes changing gears frequently for a complete engine break-in.
Guides on proper tire break-in for optimal performance and safety.
Lists essential checks for steering, brakes, tires, and fuel before riding.
Highlights the importance of the initial 1000 km service for engine longevity.
Provides advice for new riders and general riding safety.
Step-by-step procedure for starting a cold engine using the choke.
Procedure for starting a warm engine without using the choke.
Warns about the dangers of carbon monoxide in exhaust gases.
Stresses the need for adequate ventilation when running the engine.
Warns against starting the engine with insufficient fuel or oil.
Covers safety measures like speed control, posture, protective gear, and side stand.
Details the procedure for engaging first gear and moving off.
Explains proper gear selection and usage for smooth operation.
Provides guidance for climbing and descending slopes safely.
Step-by-step instructions for safely stopping the motorcycle.
Guidelines for parking securely on various surfaces.
Emphasizes maintaining a safe distance from vehicles ahead.
Covers proper braking on different surfaces and during turns.
Warns about the hot muffler and the risk of burns.
Advises removing antitheft devices before riding.
Provides specific guidance for parking on inclines.
Outlines periodic service intervals in kilometers and months.
Step-by-step instructions for safely removing the motorcycle battery.
Guidance on checking voltage and recharging the battery.
Procedure for removing the air filter for inspection or cleaning.
Instructions for draining collected oil from the pipes.
Proper procedures for installing and tightening spark plugs.
How to check the engine oil level using the dipstick.
Step-by-step guide for replacing the engine oil.
Procedure for adjusting the clutch cable clearance for proper operation.
Instructions for adjusting engine idle speed.
How to check and adjust the throttle cable play.
Items to check during regular drive chain inspection.
Procedure for adjusting the drive chain sag for proper tension.
Details on the front disc brake system and fluid checks.
Information on checking and handling brake fluid.
Inspection and maintenance of brake discs and pads.
Instructions for adjusting the rear drum brake pedal.
How to inspect the rear brake for wear limit.
Guidelines for checking and maintaining correct tire pressure.
Recommended tire pressures for solo and double riding.
Details the applicable tire sizes and standards for the motorcycle.
How to check tire wear indicators and surface damage.
Explains the function and location of front and rear brake light switches.
Guidance on using the correct wattage bulbs for replacement.
Warning against adjusting the horn mechanism.
Location of the fuse box and when to check fuses.
Step-by-step checks to diagnose and resolve engine starting issues.
Procedures for draining fuel before transporting the motorcycle.
Guidelines for preparing the motorcycle for storage.
Instructions for draining fuel for long-term storage.
How to remove, clean, store, and recharge the battery for storage.
Recommendations for tire pressure and protective agents for storage.
Advice on protecting paint and rubber parts during storage.
Steps for preparing the motorcycle after a period of storage.
Steps for checking and installing a new battery.
Guidelines for battery use, charging, and common issues.
Safety warnings related to battery handling and charging.
Physical dimensions and weight specifications of the motorcycle.
Details about the engine type, displacement, power, and lubrication.
Information on the clutch, transmission type, and gear ratios.
Key performance metrics like maximum speed and braking distance.
Details on turn diameter and tire sizes.
Details on ignition, battery, lights, and fuses.
Information on fuel tank capacity and engine oil volumes.
General| Brand | Haojue |
|---|---|
| Model | NK150 2020 |
| Category | Motorcycle |
| Language | English |
To Next Page
