EN
Haojue XPRESS 99011H17400H000 V02 EN+FR 2020-7-1 (35)
Engine oil change
Replace the engine oil with new oil after the engine is in a
hot state to completely drain the original engine oil. Steps
for engine oil replacement.
1. Stop the engine and support it on flat ground with the
help of the stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 1000 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later. The engine oil
level should be between the UPPER LEVEL and the
LOWER LEVEL.
BCAUTION
Use the engine oil recommended in the
“INSTRUCTIONS FOR USE OF FUEL AND ENGINE
OIL”.
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
Engine oil strainer
BWARNING
Due to that the cover of the right crankcase must be
removed before removing the strainer, whether the
strainer needs to be replaced should be determined
by the professional technical personnel of the
dealer.
CLUTCH
Method to inspect the clutch cable gap 4: remove the
rubber bush 1 along the clutch cable, operate the clutch
33
Haojue XPRESS 99011H17400H000 V02 EN+FR 2020-7-1 (35)
To Next Page
