Harbinger LP9800 - Front Panel Controls: Input Channels; XLR Mic and 1;4 Line Inputs; Input Channel Signal Management

6
LP9800
POWERED MIXER
LP9800 Owner's Manual
FRONT PANEL
2
3
4
5
6
7
1
XLR Mic Input Jack Channel 1-12
Balanced. Appropriate for microphones, or direct out connections from amplifiers or DI boxes.
¼” Line Input Jack Channel 1-6
Balanced or Unbalanced. Appropriate for instrument or line level equipment connections.
Input Pad Channel 1-6
Reduces the input signal by -25dB. Useful when the input signal is very strong and overdriving the
input (causing the clip light to constantly flash or remain lit).
Peak LED
This LED turns red when the input signal is clipping. If this occurs, lower the source signal output
if possible.
Channel Level
This is the volume control for individual input channels.
MON Send
This control sends the input signal to the Monitor Line Out jack and assigned Monitor power amp
(speaker output #2 when MAIN L+R / Monitor is selected in the Amplifier Assign section).
See “Amplifiers Assign Switch” on page 8.
Low EQ
This is the bass control used to boost or cut low frequencies on the input channel using a low shelf
filter with +/- 15dB of boost or cut, below 60Hz. Useful for removing rumble on vocal or acoustic
guitar inputs.