Harbor Breeze BRADBURY BRD48MBK6LR User Manual (English)

Questions and Answers:

C
Christina MontoyaAug 10, 2025
Why is my Harbor Breeze BRADBURY BRD48MBK6LR wobbling excessively?
- L
  Lindsey JenningsAug 10, 2025
  Excessive wobbling in your Harbor Breeze Fan can occur due to several reasons: * Loose blades: Ensure all motor screws and washers are tightened. * Unbalanced blades: Try switching one blade with a blade from the opposite side. * Insecure mounting: Turn the power off, carefully loosen the canopy, and verify the mounting bracket is secure. * Proximity to vaulted ceiling: Use a longer downrod or move the fan to another location. * Loose set screws on motor housing yoke: Tighten the yoke set screws securely. * Loose set screw on hanging ball: Carefully loosen and lower the canopy and verify that the set screw on the hanging ball is tightened securely.
S
shermankevinAug 17, 2025
What to do if my Harbor Breeze BRADBURY BRD48MBK6LR Fan is not working?
- A
  Ashley BrownAug 17, 2025
  If your Harbor Breeze Fan isn't moving, here's what you can check: * Reverse switch: Make sure the reverse switch is fully engaged by pushing it firmly either left or right. * Power and fuse: Verify that the power is on and the fuse hasn't blown. * Wiring: Turn the power off, loosen the canopy, and inspect all wire connections. * LED light kit wiring: Check that the molex connections in the LED light kit are properly connected.
G
gallegoswilliamAug 25, 2025
What to do if the light on my Harbor Breeze Fan fails?
- C
  Christopher FordAug 25, 2025
  If the light on your Harbor Breeze Fan is not working, consider the following: * Canopy wiring: Check the wires in the canopy. * Wall switch: Ensure the wall switch to the fan is turned on. * LED light kit wiring: Check the wires from the LED light kit.
T
Timothy SmithAug 31, 2025
How to fix a noisy Harbor Breeze Fan?
- K
  Kristopher HoodSep 1, 2025
  A noisy Harbor Breeze Fan can be caused by: * Loose blades: Tighten all motor screws and washers. * Cracked blade: Replace the damaged blade. * New fan: Allow the fan a "break in" period of a few days, especially when running it at medium and high speeds.