Page 13For technical questions, please call 1-800-444-3353.Item 60664
SAFETYOPERATIONMAINTENANCE SETUP
General Operating Instructions
1. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
WARNING! TO PREVENT
SERIOUS INJURY: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in
an unexpected direction.
CAUTION! TO PREVENT INJURY: Do not hold tool
near body while firing. Tool recoil can cause injury.
2. Disengage the Trigger Safety Lock, position
tool at desired fastener location and place the
Drive Guide fully against the workpiece.
3. Squeeze the Trigger to fire a fastener.
Note: Always make sure the Drive Guide is flush
against the workpiece during use. Always release the
Trigger once the fastener is driven into the workpiece.
WARNING! There is no contact safety for the
Trigger. When the Trigger Safety Lock is disengaged
and the Trigger is pressed, the tool will fire. Engage
the Trigger Safety Lock when not in use.
4. If the tool requires more force to accomplish
the task, verify that the tool receives sufficient,
unobstructed airflow (CFM) and increase the
pressure (PSI) output of the regulator up to the
maximum air pressure rating of this tool.
CAUTION! TO PREVENT INJURY
FROM TOOL FAILURE:
Do not exceed the tool’s
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
5. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the trigger again.
e. Clean external surfaces with clean, dry cloth.
f. Store indoors out of children’s reach.
To Next Page
Loading...
