Page 12 For technical questions, please call 1-800-444-3353. Item 60664
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects) nearby
that will present a hazard while working.
Loading the Tool
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
•Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
•Release the trigger.
•Detach the air supply.
•Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Turn the Nail Length Adjustment Knob (64)
to match the corresponding pin nail length of
the fasteners being loaded in the Nailer.
Note: When changing pin nail size, turn the
Nail Length Adjustment Knob to the new length
BEFORE inserting the new pin nails.
2. Depress the Magazine Lock (71) and pull
back on the Magazine Cover (66), fully
extending it out from the Magazine (43, 46).
3. Insert the fasteners into the Magazine.
Note: Make sure the fasteners are loaded
with pointed ends facing downward.
4. Slide the Magazine Cover back and
lock into place.
To Next Page
Loading...
