Page 11;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 58703
EF;6GHIJ6KFGLIMNFLMG6MFMO6 FEE6NPQH
G(,"7*(%R"("83
M&$*-%I87U%,%<',7"2"*9%$*4.8"4",8%#.&'79%/*(2&(5%
$.*%*7*4$("4,7%#*(V"4*%$.,$%5,U%+*%8**9*9%$&%
*8,+7*%U&'(%/,($"4'7,(%5,[*05&9*7%V*."47*%$&%
/&)*(%$.*%G(,"7*(a#%>]!TO%7"3.$"83%#U#$*51%%
G."#%"#%+*U&89%$.*%#4&/*%&2%$."#%5,8',71
1. Have a qualified service technician
LQVWDOODZLUH9'&FRQQHFWRULQ
the trunk area of your vehicle.
2. Locate the vehicle’s connector plug
near the Trailer’s Coupler and lay out
the Trailer’s wiring harness wires.
3. Connect the brown wire to the vehicle’s
left tail light by stripping, wrapping,
and taping the connector plug.
4. Connect the yellow wire to the vehicle’s
left signal and stop light wire.
5. Connect the green wire to the vehicle’s
right signal and stop light wire.
M&$*- Some foreign vehicles may require
an adapter to convert their 5-wire system
to a 4-wire vehicle connector plug.
6. Attach the white ground wire at the plug end of the
wiring harness to the small mounting hole in the
Tow Bar with a 1/4" tapping screw (not included).
7. Leave about 18" of wire beyond the Coupler and
run the wiring harness along the inside of the Right
Tow Bar to the Front Right Side Rail. Then split the
yellow/brown wires from the green/brown wires.
8. Run the yellow/brown wires along the inside of the
Front Cross Member to the Side Running Light on
the Front Left Side Rail. Run the
green/brown wires along the inside of the Front
Right Side Rail to the other Side Running Light.
9. Connect the wire lead from the two Side Running
Lights to the brown wire on each side of the
trailer, using wire connectors. Then insert wire
clips along the entire length of the side rails of
the Trailer to hold down the wiring harness.
10. Run the yellow/brown wires to the Left Tail Light,
leaving some excess wire where the frame folds.
Strip approximately 3/4" of insulation off the ends
of the wires. Connect the yellow wire to the yellow
wire of the Left Tail Light. Connect the brown
wire to the brown wire of the Left Tail Light.
11. Run the green/brown wires to the Right Tail Light,
leaving some excess wire where the frame folds.
Strip approximately 3/4" of insulation off the ends
of the wires. Connect the green wire to the green
wire of the Right Tail Light. Connect the brown
wire to the brown wire of the Right Tail Light.
RLK6%Q6FT
;KIN
ELT6%KWMMLMS%QLSXG
RXLG6%SKIWMT%RLK6
RLK6%Q6FT
;KIN
ELT6%KWMMLMS%QLSXG
PKIRM
H6QQIR
SK66M PKIRM
H6QQIR
H6QQIR
PKIRM
PKIRM
SK66M
SK66M
PKIRM
PKIRM
Q6F!6%6bO6EE%RLK6%X6K61
Q6F!6%6bO6EE%RLK6%X6K61
Q6;G%GFLQ%QLSXG%
KLSXG%GFLQ%QLSXG%
RLK6%XFKM6EE%
OIMM6OGIK%JQWS
To Next Page
Loading...
