Need help?Do you have a question about the Hardinge Talent 8/52 and is the answer not in the manual?
Steps to safely power on machines equipped with Fanuc controls.
Overview of lubrication importance, system, and recommended greases.
Details on air connections, standard, and optional configurations.
Overview of the coolant system, water-based coolants, and concentration management.
Overview of the hydraulic unit, pump, and essential maintenance procedures.
General information on battery replacement for machine controls and turret.
Guidelines for periodic cleaning and scheduled maintenance tasks based on operating hours.
Visual references for coolant pump, tank, and electrical connections.
General| Spindle Motor | 20 HP |
|---|---|
| Spindle Motor Power | 20 HP |
| Number of Tool Positions | 12 |
| Bar Capacity | 52 mm |
| Max. Swing | 400 mm |
| Max. Turning Diameter | 260 mm |
| Max. Turning Length | 500 mm |
| Z-Axis Travel | 500 mm |
| Spindle Speed | 6000 RPM |
| Turret Capacity | 12 stations |
| Swing Over Bed | 400 mm |
| Swing Over Cross Slide | 260 mm |
| Distance Between Centers | 500 mm |
| Spindle Bore | 52 mm |
To Next Page
