2005 PDI: CVO Models 7-13
12. See Figure 7-21. Plug Tour-Pak harness into power con-
nector and tuck cable assembly between seat and fender
strut cover.
NOTE
See Figure 7-22. With the radio antenna mast mounted on
the Tour-Pak antenna mount, the coaxial adapter shown in
the figure allows connecting the antenna cable to the chassis
antenna mount. With Tour-Pak removed, the adapter may be
removed and antenna mast threaded directly onto the chas-
sis antenna mount.
13. See Figure 7-23. Make certain that coaxial adapter (2) is
securely finger-tightened into the antenna chassis mount
(3).
14. Pull enough coaxial cable from Tour-Pak to reach coaxial
adapter on antenna chassis mount, allowing for a small
amount of slack in cable.
15. Screw coaxial cable connector (1) into coaxial adapter
on antenna chassis mount. Finger-tighten securely.
Figure 7-21. Connecting Tour-Pak Power Cable
10689
10690
Figure 7-22. Coaxial Adapter
Figure 7-23. Connecting Antenna Cable
(Tour-Pak Installed)
10678
1. Coaxial connector
2. Coaxial adapter
3. Antenna chassis mount
1
2
3
10679
To Next Page