2005 PDI: Touring Models 2-7
INSTALLING WINDSHIELD
FLHTC, FLHTCU, FLHTCSE
2
(Wind Deflec-
tor) and FLHTP (Fairing)
1. See Figure 2-7. Loosen the three fasteners along the top
of the outer fairing. It is not necessary to remove the fas-
teners.
2. Slide windshield down between the inner and outer fair-
ing over the fasteners. Position on the raised boss on the
inner fairing.
CAUTION
Overtightening windshield fasteners may crack wind-
shield and/or fairing.
3. Tighten fasteners to 25-30 in-lbs (2.8-3.4 Nm).
Windshield Installation: FLTR
1. See Figure 2-8. Place black plastic washers (4) on the
five mounting screws (3). Position rubber trim along bot-
tom of windshield. Insert screws through windshield
holes and thread loosely into five Wellnuts (5) with rubber
washers (6).
2. Push Wellnuts with rubber washers into holes in fairing.
3. Beginning with the center screw and working outward
toward the rear edges of windshield, tighten all screws to
6-13 in-lbs (0.7-1.5 Nm). Make certain that the four outer
screws are located at the upper end of the slots in the
windshield.
Figure 2-7. Windshield Installation–FLHT Models
pd0173x
Figure 2-8. Windshield Installation–FLTR Models
f2280x2x
1. Windshield
2. Outer fairing
3. Screw (5)
4. Flat washer (plastic) (5)
5. Wellnut (5)
6. Flat washer (rubber) (5)
1
2
3
4
5
6
To Next Page
Loading...