1. Pin housing
2. Circuit board
Figure 8-25. Pin Housing and Circuit Board
8. See Figure 8-26. Install connectors to pin housing.
9. Install lens to base with two screws. Tighten screws to
20-24 in-lbs (2.3-2.7 Nm).
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
10. Turn ignition on and test for proper tail lamp and turn signal
operation.
NOTE
Refer to Table 8-5. Cavity numbers are on back side of sec-
ondary locks. All FXDWG/FXDF components are oriented 180
degrees from above and the turn signal connectors are
reversed.
1. Tail lamp [93]
2. Left turn signal [18]
3. Right turn signal [19]
4. Power in [94]
Figure 8-26.Wire Location at Connectors
Table 8-5.Tail Lamp Wires
CAVITYWIRE COLORTYPENO.FUNCTION
1V/BN2-pin Multilock[19]Right turn signal
2BK
1V/BN2-pin Multilock[18]Left turn signal
2BK
1BE4-pin Multilock[93]Tail lamp
2HDI only-O/W or open on
domestic models
3R/Y
4BK
1O/W6-pin Multilock[94]Power in
2BN
(V on FXDWG)
3BE
4R/Y
5V
(BN on FXDWG)
6BK
8-18 2008 Dyna Service: Electrical
To Next Page