Harman Kardon AVI 250 - System Configuration; Center Channel Mode Selection; Subwoofer Setting; Multiroom Volume Control Setup

system with a subwoofer or large size
full range center channel speaker.
SMALL: Choose this option if the cen-
ter speaker is small sized.
NONE: Choose this option if you are
not using a center channel speaker.
8. When the center channel speaker
selection is complete, press the w button
@ to move to the next option. Note that
the on screen > cursor will move down
fo SUBWOOFER.
9, Press the ¢ or » buttons € to choose
one of these options:
ON: Choose this option if a Subwoofer
is installed.
OFF: Choose this option if no
Subwoofer is present.
10. Press w € once and then
SELECT @ to move to SET UP MENU
2 to continue the set-up procedure.
(Press w twice and then SELECT if
you prefer to return to the MAIN MENU.)
11. At SET UP MENU 2 (Figure #3) you
are able to establish settings for multi-
room operation and lock the control set-
tings. You may skip these menus by
pressing w €¥ until the on screen >
cursor is next fo RETURN TO MAIN MENU
and pressing SELECT @.
System Configuration
17
12. If multiroom operation will be used,
the first option enables you to select the
method used for volume control. With
the > cursor pointing to MULTI RM VOL
press the < or > buttons to choose one of
these options:
VARIABLE: Choose this option if the
volume in the remote rooms will be
adjusted by a remote control and a
sensor connected via the MULTI IR
input on the AVI250 rear panel.
FIXED: Choose this option if there
is no remote control link to the
remote rooms, or if you wish to have
the volume in these rooms remain at
a fixed, constant level.
13. When you have made your selection,
press w € to move to the next option,
SET LEVEL. Press the < or p> buttons
@® to set the volume in accordance with
the option chosen in the previous menu:
a. If you selected VARIABLE
Volume Set, this option selects the
volume level at the remote rooms
when the system is first turned on in
those locations.
b. If you selected FIXED Volume
Set, this is the level that will remain
constant in the remote rooms.
14. When you have made a volume selec-
tion, press w € to move to the next
option. Note that the > cursor should
point to SET UP LOCK.
15. This option enables you to lock the
settings at the SET UP MENU 1. This
makes it difficult for someone to inadver-
tently change the settings by causing the
MAIN MENU
INPUT SELECTOR
REC OUT SELECTOR
SURROUND MODE
TEST TONE
MULTI ROOM SEL?OFF
SET UP MENU
MENU OFF
Figure 1
SET UP MENU 1
CENTER MODE
SUB WOOFER
GO TO SET
RETURN TO MAIN MENU
Figure 2
SET UP MENU 2
MULTI RM VOL
>VARIABLE
FIXED
SET LEVEL -XXdB
SET UP LOCK LOCK
UNLOCK
RETURN TO MAIN MENU
Figure 3
TEST TONE
OF
Tee
jf El g
Figure 4
HSITSNA4