Harman Kardon AVI 250 - On Screen Display System; Input and Status Displays; On-Screen Menu Navigation

ENGLISH
line is the video input source. Remember,
when choosing an input, select the video
source first, and then the audio source if
a split input/simulcast listening session
is desired. Note that when the TAPE
COPY function is engaged, the
AUDIO source is displayed in reverse
video.
Tape Copy Input Selection
When an input is selected for either
TAPE Lor VCR1 copy, the choices
appear as a message with the TAPE]
information on the top line and the
VCR1 information on the bottom line.
(Figure #8)
Surround Output Levels
To obtain a status screen with the outputs
for each individual channel, press the
SPEAKER button @ on the remote. A
summary will appear for ten seconds.
(Figure #9)
Master Volume
When the volume is changed, a horizon-
tal scale will briefly appear at the bottom
of the screen with the volume level.
(Figure #10)
Mute
When the unit is placed in audio mute,
the word MUTE will appear in the
upper right corner of the screen as a
reminder that the volume has been cut.
(Figure #11)
On Screen Display
22
On Screen Display Function
If you do not wish to have the on screen
displays appear, press and hold the
SCREEN DISPLAY button €@ on the
remote for three seconds. A reminder
message will appear on the screen for a
few seconds (Figure #12), and the dis-
plays will then be canceled until they are
once again activated.
NOTE: Additional display messages
appear as a part of the Multiroom sys-
tem. These are described in the portion
of this manual dealing with that topic.
Using The On Screen Menus
for System Control
Besides conveying status messages, the
on screen display system may also be
used as a means of controlling the opera-
tion of the unit. To operate the control
system, always start by pressing
SELECT @ on the remote to bring up
the Main Menu. (Figure #1). Then, use
the up/down navigational arrow keys &
and W @ to move the cursor. Press
SELECT @® to choose a menu, and
then use the left/right navigational arrow
keys <q and > € to view the choices in
that current option. Finally, when the
desired choice appears, press SELECT
@ to enter the choice and return to the
MAIN MENU. To exit from the Menu
Control System, press W <€{ until the
on screen > cursor is pointing to MENU
OFF and press SELECT @.
The following functions may be adjusted
through the Menu Control System:
NASTER VOLUME
PEERS EERBORERGH |] --
Figure 10
MUTE
Figure 11
ON SCREEN DISPLAY
-OFF-
Figure 12
INPUT SELECTOR
>AUDIO *LD*
VIDEO *LD*
TAPE MONTTOR ON
OFF
RETURN TO MAIN MENU
Figure 13
REC OUT SELECTOR
>TAPE *TUNER*
VCRL *¥LD*
RETURN TO MAIN MENU
Figure 14