ADVANCED FEATURES 31
ADVANCED FEATURES
MENU line and press the Set Button o. If you
have no other adjustments to make,press the OSD
Button v to exit the menu system.
Full-OSD Time Out Adjustment
The Full-OSD menu system is used to simplify the
setup and adjustment of the AVR 225 using a series
of on-screen menus.The factory default setting for
these menus leaves them on the screen for 20 sec-
onds after a period of inactivity before they disappear
from the screen or “Time Out.”Time Out is a safety
measure to prevent image retention of the menu text
in your monitor or projector, which might happen if
menus were left on indefinitely. However,some view-
ers may prefer a slightly longer or shorter period
before the display times out.
To change the Full-OSD Time Out, you will need to
make an adjustment in the ADVANCED
SELECT menu (Figure 9).To start the adjustment,
press the OSD Button v to bring the MASTER
MENU to the screen. Press the
¤ Button q until
the on-screen ¤ cursor is next to the ADVANCED
line.Press the Set Button o to enter the
ADVANCED SELECT menu (Figure 9).
At the ADVANCED SELECT menu (Figure 9),
make certain that the on-screen
› cursor is next to
the FULL OSD TIME OUT line by pressing
the
⁄
/
¤
Buttons mq as needed. Next, press
the
‹
/
›
Buttons n until the desired time is
displayed in seconds.Note that unlike most of the
other options in this menu, this is a permanent setting
change,and the Time Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments,press the
⁄
/
¤
Buttons mq until the on-screen
›
cursor
is next to the desired setting or the RETURN TO
MENU line and press the Set Button o. If you
have no other adjustments to make,press the OSD
Button v to exit the menu system.
To Next Page
Loading...
Need help?
General
