34
34
INSTALLATION
b) Using the remote, press the AVR Power On Button or any of the
Source Selectors. See Figure 46.
Figure 46 – AVR Power On and Source Selectors
NOTES:
• Any time you press one of the Source Selectors on the
remote (i.e., Cable/Sat, DVD, Media Server, Radio, TV, Game
or AUX), the remote will switch modes to transmit the codes
programmed to operate that device. To control the receiver,
press the AVR Settings Button to return the remote to AVR
mode. Some AVR functions are available in all device modes,
and you don’t have to press the AVR Settings Button first to
use them: Volume Controls (including Mute), Audio Effects,
Video Modes, Surround Modes, AVR Settings, Info Settings,
Sleep Settings and AVR Power On and Off.
• If you are not using the AVR’s HDMI Output with your display,
you may not see a picture the first time you turn on the AVR 354,
or after a system reset. To correct this, press the front-panel
Resolution Button to display the current video output resolution.
Use the
⁄
Button to change it to 480i, which should be
compatible with all video displays, then press the OK Button
to select the new setting. You will be prompted to accept or
cancel the change; the CANCEL message will appear on the
front panel. Press the
¤
Button to view the ACCEPT option,
and then press the OK Button to complete the change to the
output resolution. Follow the directions in the Initial Setup
section to configure the AVR to function correctly with your
display and other components.
AVR354-OM-HiRes.qxd 5/22/08 4:43 PM Page 34
To Next Page
Loading...
Need help?
General
