30-second period. The message shown in Figure
90 will appear briefly, and the remote will then exit
the feature being programmed and any data entered
will be lost.
Figure 90
•
The programming or configuration process may
also be stopped at any time by pressing the
Clear
Button
9
. The message shown in Figure 90
will appear, the data entered in the current process
will be lost and the remote will retur
n to normal
operation. Any process that was underway when
the button will be pressed must be restarted.
•
Extensive use of the programming, learning and
configuration functions of the remote may consume
significantly more battery power than normal remote
operation. While the batteries should last for four to
six months in normal operation, you may find that
they need to be changed sooner after the remote is
programmed for the first time.
• When the batteries approach a level below which
the remote will not function, the remote’s LCD
screen will display a
LOW BATTERY warning,
as shown in Figure 91. We strongly recommend
replacing the batteries as soon as this message
appears to avoid the loss of programming and con-
figuration settings. These settings are
not lost when
the batteries are changed quickly.
Figure 91
T
IME OUT OR
CLR KEY PRESSED
CONFIGURING THE REMOTE 53
CONFIGURING THE REMOTE
AVR 635 OM 12/2/04 3:28 PM Page 53
To Next Page
Loading...
Need help?
General
