Need help?Do you have a question about the Harman Kardon AVR 230 and is the answer not in the manual?
General| Dolby Digital | Yes |
|---|---|
| DTS | Yes |
| Input Sensitivity | 200mV |
| Signal-to-Noise Ratio | 100dB |
| Impedance | 8 ohms |
| Type | AV Receiver |
| Input Impedance | 47k ohms |
| Total Harmonic Distortion | 0.07% |
| Surround Sound Formats | Dolby Digital, DTS, Dolby Pro Logic II |
| Digital outputs | 1 optical |
| Width | 440mm |
| Height | 165mm |
| Power Output per Channel | 50W |
| Frequency Response | 10Hz – 100kHz |
| Audio D/A Converter | 24-bit/192kHz |
| Digital inputs | 3 Optical, 3 Coaxial |
| Video Inputs | 4 Composite |
| Video Outputs | 1 Composite, 1 S-Video |
| Audio Inputs | 6 x RCA |
| Depth | 376mm |
| Audio Outputs | 1 Analog |
Controls for power, standby, volume, bass, treble, and balance.
Jacks for analog audio sources and digital audio signals.
Ports for various video signal types, including component.
Terminals for speakers and IR input/output connections.
Detailed descriptions of speaker output terminals for various channel configurations.
Ports for video signal outputs and inputs for various devices.
Connectors for video signals and digital audio inputs/outputs.
Buttons for powering devices, selecting inputs, and controlling the AVR.
Buttons to cycle through and select various surround sound modes.
Buttons to select devices and control their basic functions.
Guidance on connecting various audio sources and recorders.
Instructions for connecting speakers and initial placement advice.
Connecting subwoofers and optional external amplifiers for enhanced sound.
Connecting various video sources like VCRs, DVD players, and camcorders.
Advice on selecting and positioning speakers for optimal sound staging.
Steps to configure each input source, including digital and analog assignments.
Configuring speaker sizes for front, center, and surround channels.
Setting subwoofer operation based on speaker configuration.
Using the menu to set speaker delay times in feet or meters.
Understanding the EzSet calibration process and indicators.
Explains OSD modes and the process of making configuration adjustments.
How to select surround mode categories like Dolby, DTS, and Logic 7.
Setting up surround back channels and subwoofer configuration.
Importance of correct output levels for balanced surround sound.
Configuring speaker sizes and bass management settings.
Adjusting bass management and crossover points for optimal audio.
Compensating for speaker distance with delay time adjustments.
Step-by-step guide to using the EzSet remote for automatic level calibration.
Turning the unit on/off and selecting audio/video sources.
How to change surround modes using front panel or remote controls.
To Next Page
