Remote Control Programming & Operation
13
ENGLISH
Another group of keys may only be
programmed with one remote code. The
code contained in these keys remains the
same regardless of the source selection.
WARNING: These keys transmit codes
that are vital to the operation of the
product. It is not recommended that they
be programmed with alternative codes, as
it may then be impossible to operate
certain functions of the receiver.
Aux
Cursor Up
⁄
Pro Logic
Delay
Cursor Down
¤
Dolby 3 Stereo
Memo
Cursor Right ›
Movie
Screen Display
Cursor Left ‹
Matrix
Panel Display
Select
Hall
Speaker
Main Volume Up
⁄
Stereo
Test Noise
Main Volume Down
¤
Adjust
Mute
RDS PTY
RDS AF
To program theremote, you need the
remote of the device, whose functions
shall be programmed. Note thatit isnot
necessary to programall keys,only those
that are requiredto operatethesubject
device. Keys notprogrammed willretain
the codes preprogrammedat thefactory.
1. Slide Use/Learn a switch at the top
left corner of the remote to the right so
that it is next to Learn.
2. If one of the multi-function buttons
is being programmed press the source
button (i.e. CD, VCR, etc.) you wish to
have this function associated with. If you
are programming a single function key,
proceed to the next step.
3. Press the button on the remote that
is to be programmed. Note that the
Learning y LED will illuminate.
4. Place the remote head to head with the
remote control whose function is being
learned. The two remotes should be no
more than 8 inches apart.
5. Press and hold the button on the
transmitting remote corresponding to the
function to be memorized until the
Learning LED starts to blink. When the
LED goes out, release the button on the
transmitting remote. The function code
has been successfully captured.
NOTE: If both LEDs flash during a
programming operation, it indicates that
the remote’s memory is full or that
the remote codes from the transmitting
remote are not compatible with the unit’s
signal format.
6. Continueto programanyadditional
remote commandsrequired usingsteps
2 through5. Whenyouhave finished
programming theremote, slidethe
Use/Learn switch to theleftso thatit
is inthe Useposition.
Clearing the Remote Memory
In normal operation, codes for a new
device may be programmed “over”
the codes that have been previously
programmed into the remote. It is also
possible to clear the memory for
individual keys, or for the entire remote.
When
a memory position is cleared, the remote
will return to the original factory preset
command.
To clear the memory for a specific
individual key location, put the
Use/Learn switch in the Learn
position. Press the Main Power Off b
button and the button to be cleared at the
same time. Both the Sending and
Learning indicators will light
momentarily. When
the lights go out, the memory has been
cleared of the user programmed code and
returned to the factory preset. Return the
Use/Learn a switch to the Use
position when you are finished.
To clear the remote’s entire memory
and return all keys to their factory preset
commands first put the Use/Learn a
switch in the Learn position. Then press
the Main Power On button b and
confirm that the Learning indicator y
has illuminated. While continuing to
press the Power On button, press and
hold the Power Off b button until the
Learn indicator goes off for about 3
seconds. It will then blink twice. Then
release the two buttons. This indicates
that the memory has been cleared of any
user programmed commands and that
the original commands have been
restored. Slide the Use/Learn switch
back to the Use a position to return
the remote to normal operation.
AVR70 engelsk manual 11/01/98 11:57 Side 13
To Next Page
Loading...
Need help?
General
Weight and Dimensions
