Operation
11
ENGLISH
Auto Tuning
1. Press the FM/AM 6 button to select
the tuner as an input and the desired
frequency band.
2. Press the SEEK/STEREO #
button, so that the AUTO indicator in the
display goes on.
3. Press the TUNING/PTY
⁄¤
&
button once and tuning will start in the
direction indicated. The tuner will stop at
the next station with sufficient signal
strength.
Preset Memory
Up to 30 stations may be stored in the
receiver’s memory for easy recall using
the front panel controls or the remote.
To enter a station to the memory, first
tune to the station using the steps
outlined above in the Manual Tuning
section. Then:
1. Press the MEMORY @ button on the
front panel. Note that the MEM indicator
in the information display window will
illuminate and flash.
2. Within five seconds, press the station
preset ! button corresponding to the
memory location where you wish to store
this station’s frequency.
• To enter a station to memory location
“30” press only the “0” button.
3. Repeat the process after tuning to any
additional stations to be preset.
Recalling Preset Stations
To select a station that has previously
been entered into the preset memory
simply press the station preset ! buttons
on the front panel or the numeric e
buttons on the remote corresponding to
the desired station’s location. To select
the station in location “30”, press the 0
button only.
• When you select a station using this
method the unit will automatically
switch to the tuner as its input.
Preset Station Scan
To automatically scanthrough thesta-
tions that havebeen enteredto thepreset
memory, press theP•SCAN d button
on the remote.The tunerwill automati-
cally begin tosearch throughthe listof
stations, stopping forfour secondsat each
one. Press theP•SCAN button again to
stop the scanat yourdesired station.
RDS OPERATION
Your AVR11 is equipped with RDS (Radio
Data System), which brings a wide range
of information to FM radio. Now in use in
many countries, RDS is a system for
transmitting station call signs or network
information, a description of station
programming, text messages about the
station or specifics of a musical selection
and the correct time.
As more FM stations become equipped
with RDS capabilities, the AVR11 will
serve as an easy to use center for both
information and entertainment. This
section will help you to take maximum
advantage of the RDS system
RDS Tuning
To tune stations that are broadcasting
RDS data press the RDS ^ button on
the front panel and note that the RDS
indicator illuminates in the front panel
display window.
Next, press the TUNING/PTY & button
in either the
⁄
or ¤ direction. The
unit will automatically seek the first
station with RDS data and stop there. The
station name or programme service
information will be displayed in the
information display window in place of
the normal frequency display.
Press the TUNING/PTY & button
again to tune to the next RDS station.
Remember that the RDS ^ button must
be pressed again to tune all stations, not
just those sending RDS data.
AVR11 engelsk manual 11/01/98 10:46 Side 11
To Next Page
Loading...
Need help?
General
