Harman Kardon AVR20 II User Manual

10. VCR 1 REC
Press the VCR 2 button and VCR1
DUBBING button. Set the recording
VCR (VCR 1) to recording mode. Set
the playback VCR (VCR 2) to playback
mode.
Dubbing will start.
M@ To hear another input source
during video tape dubbing: Press
the input function you want to
hear, and play the input source.
NOTE: If you press the TEST TONE
button during VCR 1 DUBBING, the
audio signal is not recorded.
11. PRESET SCAN BUTTON
Press this button to scan the preset
Station frequencies. The receiver
stops at each preset location that
contains a frequency for about 4
seconds, so you can hear a station.
The preset location indicator blinks 4
times. Press this button again to stop
scanning.
12. SEARCH SELECTOR
_ Press this button to select AUTO or
MANUAL tuning.
M In AUTO mode, scanning is
automatically continued up or
down until the next station is
picked up by pressing the
UP/DOWN tuning button. The
display window shows ‘SEARCH’.
Use this mode to quickly find
strong AM or FM stations.
M@ In MANUAL mode, the frequency
is changed by a step with the
UP/DOWN button. If you keep
pressing the UP/DOWN tuning
button, scanning is continued until
the button is released.
NOTE: Tuning Intervals:
BAND na
FM 50 KHz
AM 10 KHz
13. FM MODE BUTTON
Press this button to select stereo or
mono mode.
M STEREO: Provides stereophonic
reception of an FM stereo
broadcast. The display window
shows ‘STEREO’.
M@ MONO: The left and right
channel signals detected from an .
FM stereo broadcast are mixed
and reproduced through both
channels. If you want to find a
~ weak FM station, select this
mode. The display window
shows ‘MONO’.
14. STATION MEMORY
BUTTON
Use this button to store an AM or FM
frequency. Press this button and
select one of 30 preset locations to
store the frequency with the STATION
PRESET buttons while the memory
indicator, ‘MEMORY’ blinks. NOTE:
When you store a frequency in a
memory location that already contains
a frequency, you replace the previous
frequency. If your receiver is
disconnected from AC power for more
than about 10 days, it loses all stored
frequencies.
15. UP/DOWN TUNING
BUTTONS
Press the DOWN button ( v ) to tune in
lower frequency stations, the UP button
(4) to tune in higher frequency
stations. If you press the DOWN
button when the display is at the
bottom of the frequency range, the
display returns to the top of the range.
If you press the UP button when the
display is at the top of the frequency
range, the display returns to the bottom
of the range. When the receiver finds
a strong frequency, the display window
shows ‘TUNED’.
16. FM/AM BAND SELECTOR
Press these buttons to select the FM
or AM radio band. When you select
the AM or FM radio band, the receiver
displays the last frequency selected on
that band.
17. STATION PRESET
BUTTONS 7
Select one of 30 preset locations to
recall the station stored in memory.
The input function is automatically
changed to TUNER when the button is
pressed. When you select numbers
from 10 through 29, you must select
the second digit within about 2
seconds. To select preset 30, simply
press “O".

Harman Kardon AVR20 II Specifications

General

Brand	Harman Kardon
Model	AVR20 II
Category	Receiver
Language	English