To Next PageTo Next Page
Need help?Do you have a question about the Harman Kardon AVR80 and is the answer not in the manual?
Audio Section| stereo mode continuous average power | 95 Watts per channel 20Hz–20kHz |
|---|---|
| five channel surround mode front L&R channels power | 85 Watts per channel from 20Hz–20KHz |
| five channel surround mode center channel power | 85 Watts from 20Hz–20kHz |
| five channel surround mode surround channels power | 60 Watts per channel from 40Hz–20kHz |
| input sensitivity/impedance linear | 220mV/50 Kohms |
| input sensitivity/impedance front main in | 1.5 V/20 Kohms |
| input sensitivity/impedance center main in | 1.5 V/20 Kohms |
| input sensitivity/impedance surround main in | 1.0 V/20 Kohms |
FM Tuner Section| frequency range | 87.5–108.0MHz |
|---|---|
| usable sensitivity IHF | 1.3 µV/13.5dBf |
| signal to noise ratio mono/stereo | 76/68dB |
| distortion mono/stereo | 0.2/0.5% |
| stereo separation 1 kHz | 40dB |
| alternate channel selectivity (±300kHz) | 55dB |
| image rejection 98MHz | 70dB |
AM Tuner Section| frequency range | 531–1602 / 152–282kHz |
|---|---|
| signal-to-noise ratio | 50dB |
| usable sensitivity loop | 500µV (MW) / 1500µV (LW) |
| distortion 1kHz, 30% mod | 0.5% |
| selectivity ±18kHz | 70dB |
Video Section| television format | PAL, NTSC, SECAM |
|---|---|
| input level/impedance | 1Vp-p/75ohms |
| output level/impedance | 1Vp-p/75ohms |
| video frequency response | 10Hz to 8MHz (–3dB) |
| S/N | 65dB |
General| power requirement | AC 230V 50Hz |
|---|---|
| signal to noise rate (IHF-A) | 95 dB |
| channel separation | 40dB |
| frequency response @ 1W (+0, –3dB) | 7Hz–80kHz |
| high instantaneous current capability (HCC) | ±30 amps |
| power consumption | 54W idle, 700W maximum |
| dimension width | 440 mm (17.4 inches) |
| dimension height | 160 mm (6.4 inches) |
| dimension depth | 459 mm (18 inches) |
| weight | 15 kg (31 lbs.) |
| rise time | 16µsec |
| slew rate | 40 V/µsec |
