Programmed Play Operation
14
ENGLISH
To remove tracks from the middle of a
previously programmed sequence, press
the
Check @ o button, and then press
the
Skip buttons 8 h until the desired
track number appears in the display. Press
the
Clear e or Stop/Clear 5 button
to remove the track from the sequence.
Repeat Programmed Play
The HD760’s programming system enables
you to repeat either a single track, the
entire disc (respectively all programmed
tracks) or a specially programmed passage
that you select.
Repeat All
To repeat all of the tracks on a disc, press
the
Repeat 1/All button f or the
Repeat button $ once until the REPEAT
and ALL indicators light up. When you see
these indicators, the entire disc or all
programmed tracks will play through to
the end, and then start again from the
beginning. The disc will play continually
until the
Stop button 5 k is pressed.
Repeat One
To repeat the track in play, press the
Repeat 1/All button f or the Repeat
button $ twice. The REPEAT and ONE
indicators will light and the track will
continue to play over and over again
continuously. If the track is changed by
pressing the
Skip buttons 8 h while the
Repeat function is in use, the newly
selected track will be repeated. To stop the
repeat play, press the
Stop button 5 k
or press the Repeat button $ f until
the
REPEAT indicator goes out.
Repeat A–B
The HD760 may be programmed to repeat
any section within a track, or a complete
passage or program that includes material
in a series of tracks.
To program the unit for A–B play, first
locate the point on the disc where you wish
to begin the repeated section. At that point,
press the
Repeat A–B button g. The
REPEAT indicator will light in the
Information Display and the A–
indicator will blink to show that the
program process has started. Let the disc
continue to play or press the
Search
—
button 7 i or Skip
fl·
button 8 h
on the front or remote until you have
reached the end of the section to be
repeated. When the end point is reached,
press the
Repeat A–B button g again.
Note that the
REPEAT and A–B indicators
will now be illuminated.
Once the
Repeat A–B button g is
pressed for the second time to complete the
programming, the HD760 will
automatically go to the start of the selected
passage and continue to play the section
over and over.
To resume normal play press the
Repeat
A–B
button g again. The REPEAT and
A–B indicators will go out, and the rest of
the disc will play normally.
Auto Play
The HD760 may be programmed to
automatically go into the play mode when
the unit is turned on.
To use this feature, insert a disc in the
drawer and close the drawer as explained on
page 10. Next, locate the
Autoplay switch
¢ on the rear panel. Place the switch in the
ON position and then either turn the unit off
by pressing the front panel
Power Switch
1 until the Status Mode Indicator 2
goes dark, or place the unit in the Standby
mode by pressing the
Power Off button
a on the remote.
When the HD760 is turned on using either
the Power Switch 1 or the Power On
button b the unit will automatically go
into the Play mode and the disc will play
through from the first track to the last.
To return the unit to normal operation,
put the
Autoplay switch ¢ in the OFF
position.
To Next Page
Loading...
