Harman Kardon HK3500 - AC Power and Speaker Connections

INSTALLATION
"AVIS. PIESQUE DE CHOC
ELECTROUF NE PASOLVAIR,
AC Power
Plug the cord into a polarized wall socket,
or polarized extension cord.
AC Convenience Receptacles
Other stereo components may be plugged
into the back of your receiver.
1. If acomponent is plugged into the
“Switched” receptacle, power will be
supplied to that component only when
your receiver is turned on.
2. Ifa component is plugged into the
“UOnswitched” receptacle, power will be
supplied whether your receiver is on-or
off.
NOTE: Do not connect any component
that requires more than 180 watts of power.
Check the owner's manual or the back of
the component to find its power
requirement.
Connecting
Speakers
4.
Connect
terminals
on
the
left-hand
1.
speaker to the “Left” and corresponding
“GND?” terminals on the receiver, again
being careful to maintain correct
For best performance, use high quality
speaker cables. However, ordinary
copper wire can be used if the gauge
meets the following requirements: polarity.
Wire
Length
Gauge
5.
If
you
are
using
a
second
set
of
Up
to
8
feet
18
AWG
speakers,
connect
them
in
the
same
Upto12feet
16AWG
way
to
the
terminals
marked
“Speaker
Up
to
20
feet
14
AWG
System
2.”
Over
20
feet
10-12
AWG
custom
speaker cable
Avoid coiling excess wire with or near
line level hook-up cords.
Note the difference between the two
conductors in each cable: different
colored insulation, ridged insulation, or
colored yarn. Connect the right-hand
speaker to the receiver, being careful to
connect the positive terminal on the
speaker to the terminal marked “Right”
on the receiver, and the negative or
ground terminal on the speaker to the
corresponding “GND” terminal on the
receiver.
OOO!
RIGHT GND GNC
RIGHT GND GND
OOO!
CAUTION
ATTENTION
E CHOC
E PAS OUVRIR.