Harman Kardon HK3500 - Speaker Operating Mode Settings

SPEAKER OPERATING MOOE
SPEAKER
») Syste" m8) mat)
FT
<—lo @ «
SWITCHED UNSWITCHED
MAX 180W.1.54 I MAX 180W,1.54
IMPORTANT: When connecting two pairs
of speakers, determine the impedance of
each pair by looking on the back of the
speakers, or in your owner’s manual, or by
contacting your dealer or manufacturer.
Then refer to the following chart to see if
both sets may be played simultaneously.
Ifimpedance Can both pairs
of the two be played
pairs is: simultaneously?
80/80. YES
8Q/EQ NO
80/42 NO
6Q/6Q NO
6Q/4Q NO
4Q/4Q NO
WARNING: Do not play both sets of
speakers simultaneously except as
recommended above. Receiver may
overheat.
Setting the Speaker Operating Mode
1. Determine the impedance of your
speakers by looking on the back of the
speakers or in your owner’s manual, or
by contacting your dealer or the
manufacturer.
2. Be sure Power switch is turned off.
3. Locate the switch marked “4Q/8Q” on
the back of the receiver.
@ /f you are connecting only one set of
speakers, and their impedance is
8Q, set the switch to 82.
M@ |f your speaker's impedance is less
than 8Q, or if you are connecting
two sets of speakers, regardless of
their impedance, set the switch to
4Q.
NOTE: If you change or add speakers, be
sure to reset the switch accordingly.