SUB-TS10 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
¡ Speaker-Level Inputs: Connect these
binding post terminals to the main left and
right speaker terminals of your receiver or
amplifier,if your receiver or amplifier does
not have a line-level subwoofer output.
Remember to maintain polarity by connecting
the (+) terminal on the receiver/amplifier to
the (+) terminal on the SUB-TS10 subwoofer,
and the (–) terminal on the receiver/amplifier to
the (–) terminal on the SUB-TS10 subwoofer.
™ Speaker-Level Outputs: If you are
using the Speaker-Level Inputs ¡ on
the SUB-TS10, you should connect these
binding post terminals to your front left and
right speakers, remembering to maintain
polarity by connecting the (+) terminal on
the SUB-TS10 subwoofer to the (+) termi-
nal on the speaker, and the (–) terminal on
the SUB-TS10 subwoofer to the (–) terminal
on the speaker. If you are not using the
Speaker-Level Inputs ¡, then connect
your front left and right speakers directly to
your receiver or amplifier. See pages 6 and
7 for further information.
£ Line-Level Subwoofer (SUB) Input:
Connect the subwoofer output of a receiver
with digital surround sound decoding, such
as Dolby* Digital or DTS
®
, to this input.This
input bypasses the SUB-TS10’s internal
crossover circuitry, and should only be used
with a filtered signal. If your receiver does
not have digital decoding, you should use the
Line-Level Full-Range Inputs ¢ instead.
¢ Line-Level Full-Range Inputs: Con-
nect the line-level subwoofer output or
preamp output(s) of your receiver or amplifier
to these inputs. If your receiver does not have
a separate subwoofer output,use a Y-adaptor
(not supplied) to bridge the receiver’s preamp
output to the main amp input for that chan-
nel, and connect the long end of the adaptor
to the corresponding line-level input on the
SUB-TS10. If your receiver has only a single
subwoofer output, you may connect it to
either the left or right line-level input on the
SUB-TS10, and no Y-adaptor is needed.
∞ Phase Switch: This switch determines
whether the SUB-TS10 subwoofer’s piston-
To Next Page
Loading...
