Harman Kardon Onyx Studio - Page 27

Harman Kardon Onyx Studio
Assembly procedure
the MB shown in the figure. it shouldn’t pass by the upper screw.
13. 取 4PCs 泡棉粘貼到按鍵板指定位置
Assemble 4 sponges to the switches shown in
the figure.
注意：泡棉粘貼在白線中間位置，兩側靠末端
粘貼，長於部份朝缺口側粘貼
Note: If the length is longer, please stick near
the gap.
14. 將按鍵板從排線接口位置開始組裝，再依
次左右兩側卡入面框
Assemble the Cable first and then assemble the
both sides of the keys.
注意：按鍵板需注意組裝方法，防止折斷按鍵
板
Note: Do not bend the key PCB.
多餘部份朝缺口
側粘貼
藍牙鍵
“-”鍵
“+”鍵
注意：按鍵板先裝
接口位置