Harman Kardon Onyx Studio - Page 28

Harman Kardon Onyx Studio
Assembly procedure
15. 取 Rubber Ring 對準按鍵處依次往面框側
組裝
Assemble the rubber ring and align the keys by
sequence.
注意：Rubber Ring 需注意組裝方法，需卡到
位
Note: Take care the assembly method and its
position.
16. 把 Back Radiator 組裝到後殼對應位置
(Front Radiator 安裝位置有防呆設計)；取螺絲
起子，依次鎖付 4PCs 螺絲(3*10.2MM)
Assemble the Back Radiator to the back of back
cover shown in the figure. Tightens 4 screws by
using the T10 screwdriver.
Rubber Ring
“-”鍵
“+”鍵
Power 鍵
藍牙鍵
Back Raditor 以
凸起定位
2
3
4
1