Harman® • Absolute63 Owner’s Manual_R6 • 2016 -___ • 11/179
3-90-999000c
ISSUES SOLUTIONS
Metallic noise. Noise is caused by metal expanding and contracting as it
heats up and cools down, similar to the sound produced
by a furnace or heating duct. This noise does not affect the
operation or longevity of your appliance.
White ash buildup on glass. Thisisnormal.Cleantheglassusinganynon-abrasiveglass
cleaner.
Glass has buildup of black soot. Excessive build-up of ash. The lower burn settings will
produce more ash, the higher burn settings produce less.
The more it burns on low the more frequent cleaning of the
glass is required.
Glass has turned dirty. Excessive build up of ash. The lower burn settings will
produce more ash, the higher burn settings produce less.
The more it burns on low the more frequent cleaning of the
glass is required.
Firehastallameswithblacktailsandislazy. The feed rate needs to be reduced or the burnpot needs
cleaning.Heatexchangerorexhaustblowerneedscleaning.
Smokystart-uporpuffsofsmokefromtheairwash. Burnpot may be dirty, clean the burnpot.
Largeameatstart-up. This is normal. Flame will settle down once the re is
established.
Missed Ignition. Ensure there are pellets in burnpot.
Ensure holes in burnpot are clear of obstructions above the
igniter. See Burnpot Maintenance.
Check to see if the ignitor is getting hot, if not replace ignitor.
*See manual ignition instructions for emergency heating
needs.
I. Frequently Asked Questions
Withproperinstallation, operation, and maintenance your appliance will provide yearsoftrouble-free service. If you do
experienceaproblem,thistroubleshootingguidewillassistinthediagnosisofaproblemandthecorrectiveactiontobe
taken.
Contact your dealer for additional information regarding operation and troubleshooting. Visit www.harmanstoves.
com to nd a dealer.
Touch Up Paint
Thetouchuppaintprovidedwithyourunitisforxingminorchipsorblemishesthatmayoccurafterstoveinstallation.
Unfortunately,becausethenishofyourstoveisbakedon,thistouchuppaintmaynotbeaperfectmatchtothecolorof
theoriginalnish.
To use this touch up paint: Ensure the stove is cool and that the surface to be painted is clean. Apply in several light coats
andtakecaretoonlycoatthechippedarea.Allowthepainttodryfor24hoursbeforetouchingorringthestove.