Harman AKG WMS420 - Safety and the environment; Safety; Environment

Note:
3.3 Aligning the
Microphone
Fig. 7: Adjusting
the
gooseneck.
Refer to fig. 7
.
Both
the
headband
and
temple
pieces
are
made
of spring steel
wire. lf
you
bend the wire
too hard
it may be extremely
difficult to bend
the
wire
back
to
the desired
shape.
.
Adjust
the
gooseneckso
as
to
point
the micro-
phone
at the corner
of
your
mouth.
Never try to shift
the
gooseneck
inside the
holder, This
would
damage the
gooseneck
and/or holder.
lf the
moisture shield
gets
damaged,
replace
it
with
the supplied
extra
moisture
shield
as
shown
above.
To
clean the microphone
sur-face,
use
a soft
cloth moislened
with
water.
Clean the foam
windscreen
in mild
soap suds.
You
can use the
windscreen
again
as soon
as it
has
dried.
AKG
C
555 L
a
¡[lmeonantr
3"4 Ad¡ust¡ng
the
Microphone
Arm
Fig. B: Adjusting
the microphone
arm,
'18
a
3.5
Replacing
the Moisture
Shield
Fig.
9:
Replacing
the moisture
shield.
Refer to fig. 9
4.1
Mierophone
Surfaoe
4,2 Windsereen
19
Refertofig.S. 1.
Unsnap the
goose-
neck
(1)
from
the
holder
(2).
2.
Snap the
gooseneck
(1)
back
into the
holder
(2)
at the
desired
position.
AKG C 555 L
4
3
\-Ð
2
\ç
1
ø