Harman HydroFlex 60 Pellet Boiler - Starting After an Empty Hopper, Turn Feed Adjuster to TEST

29
3-90-233R24_11/13
4. If Starting After an Empty Hopper, Turn Feed Adjuster
to “TEST” (forone60secondcycle).Thiswillcharge
pelletsintotheaugertubeandalsoallowyoutocheck
themotorsforoperation.NOTE: The auger motor will
not operate with any of the doors or hopper lid open.
5. Turn Feed Adjuster to #5. Ifthisisyourrstreoryouare
tryinganewfuel,setthefeedadjusterto#5.Thissetting
workswellwiththeaveragewoodpellets,butmayneed
adjustedforyourparticularfuel.Afteryouknowafeed
ratesettingthatworkswellforyourapplication,stickwith
thatsetting.
NOTE: You know your feedrate istoo high when: The
overheatsafetyfeatureisenergizedeachtimetheheating
zonedemandturnsoffduringahighburn.OR,Ifunburned
orpartiallyburnedpelletsarefoundintheashpan.(thismay
alsoindicateaneedforscrapingtheburnpot)
If you need to keep the feed adjuster on it’s maximum setting,
your unit is under-sized for the heating system. Continuous
operation at maximum burn rate may cause pre-mature failure
of the rebox bafes.
Note: The rebox bafes (#1-10-232052) are considered
to be a consumable item, and are therefore not covered
by the product warranty.
6. Flip the Igniter Switch up into the“AUTO”position.
Due to low water temperature, the initial start will be
a longer process than when the water temperature is
closer to the minimum setting.
7. Turn the MAX. TEMP. Dial onthecontrolboardtothe
desiredtemperature.Thissettingmustalwaysbeatleast
5°F.higherthantheMIN.TEMP.setting.
Operation
WATER TEMPERATURE
MAX. TEMP.
MIN. TEMP.
WARNING
!
HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP
CHILDREN, CLOTHING, AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS.