14
CPi2000 Cinema Processor
User Guide
5. Analog Input
The 8-channel Analog Input uses a female HD-25 connector and is designed to receive 300mV
RMS
(ref) inputs from
external sources.
6. USB Connector
This Type-A USB connector can connect to a USB flash disk from preset saving or loading.
7. Redundant Output
This Redundant Output installs a male HD-25 connector which will bypass the CPi2500 system and directly output
audio signals in case an operation failure appears to the cinema processor. (NOTE: the Redundant Output must work
together with Analog Input (5 @ rear panel). )
8. LAN Port
The LAN port uses a RJ45 connector with activity LEDs and provides an interface for TMS (Theatre Management
System) communication. This port can also be used for GUI software operation or firmware upgrades.
9. Analog Output 1
The 8-channel Analog Output 1 uses a male HD-25 connector and is compatible with third party audio systems.
10. Backup DC Power Input
This is a 4-pin female XLR connector for use with Cat. No. 994 External Power Supply. This input connects to the
+12V 2A DC power adapter (Please consult or purchase from your local dealer or the manufacturer).
11. Analog Output 2
The Analog Output 2 includes ten male HD-15 connectors (Left 1, L/R 2, Center 1, Center 2, Right 1, LS/RS 1, LR/RS 2,
BLS/BRS, SW 1, SW 2) and connects to CROWN cinema amplifiers for analog audio output and fault detection signal
input. They can be set up through the GUI software.
To Next Page
Loading...
