14
A. LCD Panel
The LCD is used to display basic diagnostic information and allow access to more advanced features through a menu system.
See the LCD GUI specication for more details on the LCD menu system, features, and navigation. The LCD will refresh at
approximately 4Hz and is not suitable for meters or any other fast motion items.
B. Power Button
The Power Button is a momentary push button. It is used to toggle the unit between the On and Off states. When in the
Off state, a short press and release of the Power Button will put the unit into the On state.
C. Main Volume / Menu Navigation
Controls LCD Display
• Rotary encoder: In Menu - Clockwise down menu/Anti-clockwise up menu
• Press to select menu item
• + On Home screen, Main Volume increase by rotating the knob clockwise.
+ On Home screen, Main Volume decrease by rotating the knob counterclockwise.
D. Limit LED
Amplier is reaching clip.
E. Back Button
Press to return to previous menu item
F. Power Inlet
Inlet adapter for A/C power cable
G. XLR Male Loop Thru
This XLR output connector provides a method of sending audio out to an external source. If signal is present on all inputs, the inputs will
be summed and sent out as a mix: Can be adjusted in the pass through menu section..
H. CH2 XLR-1/4” Combo Input
XLR – 1⁄4” combination connector (1 for each input) are used for the analog audio inputs.
MIXER PANEL FUNCTIONS
To Next Page
Loading...
Need help?
General