EasyManuals Logo

Harman P61 User Manual

Harman P61
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Harman® • P-Series Owner’s Manual_R23 • 2014 - ___ • 02/1924 3-90-436168c
B. Loss of Power
Minimizing Smoke During Loss of Power Using Battery
Back-up
Harman® strongly recommends installing battery back-
up to minimize entry of smoke into the room in the
event of power loss.
Your pellet/biomass burning appliance relies on a
combustion blower to remove exhaust. A power failure will
cause the combustion blower to stop. This may lead to
exhaust seeping into the room. Vertical rise in the venting
may provide natural draft. It is, however, no guarantee
against leakage.
There is one Harman® approved UPS option for your
appliance:
Uninterruptible Power Supply UPS battery back-ups are
availableonlineoratcomputerandofceequipmentstores.
Your Harman® appliance with Rev E or later software
available beginning in November 2010 may be plugged
directly into a Harman® approved UPS:
TrippLite model INTERNET750U is tested and
approved. Other brands or models may not be
compatible.
When power is lost, a fully charged UPS will power a safe,
combustion blower only shut-down. Your appliance will
pulse the blower every few seconds to clear exhaust until
thereisout. NOTE: The UPS provides safe shut-down
only. It is not intended for continued operation.
A Inverter/Charger connects to a 12 volt deep cycle
battery that will run your appliance for up to eight (8)
hours. It includes a trickle charge feature that keeps your
battery charged when power is available. NOTE: If the
power is out for longer than battery life, smoke leakage
may still occur unless your stove has been safely shut
down.
For an approved Inverter/Charger refer to www.
harmanstoves.com.
Your appliance will recognize when power is restored. What
happens depends on ESP temperature and whether it is
equipped with automatic ignition:
In “Automatic” Mode, units equipped with automatic
ignition will respond to the set point and ESP temperature
and resume normal operation.
In “Idle” Mode, or for units without automatic ignition:
If the ESP is cool, the appliance will remain shut
down.
• IfthereisoutandtheESPisstillwarm,thefeeder
mayrestart.Sincethereisout,theESPtemperature
will not rise. The unit will then shut-down, and may
ashasix-blinkstatuserror.(SeeESPerrorcodes)
• If the re is still burning, it will resume normal
operation.
Contact your dealer if you have questions about UPS
compatibility with your appliance.
Use only Harman
®
approved battery back-up devices.
Other products may not operate properly, can create
unsafe conditions or damage your appliance.
CAUTION
!
Always keep appliance doors and hopper lid closed
and latched during operation and during power
failures to minimize risk of smoke or burn-back.
D. Emergency Manual Ignition
Harman
®
pellet stoves and inserts should be lit using the
automatic ignition system. This is the safest and most
reliable way for igniting the unit. In the event the automatic
igniter is not functioning, the steps below may be followed
to manually light the stove or insert in the “Constant Burn”
mode. Manual lighting is for emergency purposes only,
and the igniter should be repaired or replaced as soon as
practical.
WARNING
!
Only use restarter commercially marketed for pellet
stoves and inserts, including wax coated wood chips,
pellet starter gel and pellet igniter blocks. Use of any
othertypeofrestarterisprohibited.
To avoid serious injury or death read and follow
manufacturer’swarningandinstructionsforuseofrestarter.
Useofrestarterisonlypermittedwhenperformingacold
start.
Never attempt to manually light a stove or insert that has
been operated recently and is not at room temperature.
If automatic ignition was attempted, be sure to give the
stove or insert at least 30 minutes or longer to cool to room
temperature.
Be sure that the stove or insert is in the “Igniter - Disabled”
mode of operation.
Once all the precautions have been taken, follow these
steps:
1.TurntheModeSelectorto“OFF”.
2.Fillburnpotwithpellets,onlyhalfway.(DoNotOverFill).
3. Add firestarter to pellets following manufacturer’s
instructions.
4. Light pellet gel with a match, and close the door, turn Mode
SelectortoConstantBurn.Operationwillbeginwhenthe
rereachesthepropertemperature.
WARNING
!

Other manuals for Harman P61

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Harman P61 and is the answer not in the manual?

Harman P61 Specifications

General IconGeneral
BlowerYes
Ash PanYes
EPA CertifiedYes
TypePellet
Weight320 lb

Related product manuals