Harman PF-120 - 2 Getting Started; Tools And Supplies Needed; Inspect Appliance And Components

Harman® • PF-120 Installation Manual_R1 • 2014 -___ • 03/145
3-90-08121i
2
Getting Started
ReciprocatingSaw
Hammer
PhillipsScrewdriver
TapeMeasure
Level
Non-CombustibleSealant
Material
Gloves
SafetyGlasses
ElectricDrill&Bits
Mayalsoneed:
VentSupportStraps
VentingPaint
Tools and building supplies normally required
for installation, unless installing into an existing
masonry replace:
A. Tools And Supplies Needed
B. Inspect Appliance and Components
•  Carefullyremovetheapplianceandcomponentsfromthe
packaging.
•  Theventsystemcomponentsanddecorativedoorsand
frontsmaybeshippedinseparatepackages.
•  Reporttoyourdealeranypartsdamagedinshipment,
particularlytheconditionoftheglass.
• Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benet.
WARNING! Risk of Fire or Explosion! Damaged parts
could impair safe operation. DO NOT install damaged,
incompleteorsubstitutecomponents.Keepappliancedry.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this appliance if any part has been under
water. Call a qualied service technician to inspect the
appliance and to replace any part of the control system
and/or gas control which has been under water.
OPERATE THE GAS-FIRED UNIT (If applicable)
PERIODICALLY TO ENSURE THAT IT WILL OPERATE
SATISFACTORILY WHEN NEEDED.
Hearth&HomeTechnologiesdisclaimsanyresponsibility
for, and the warranty will be voided by, the following
actions:
•  Installationanduseofanydamagedapplianceorvent
systemcomponent.
•  Modicationoftheapplianceorventsystem.
•  InstallationotherthanasinstructedbyHearth&Home
Technologies.
•  Installation and/or use of any component part not
approvedbyHearth&HomeTechnologies.
Any such action may cause a re hazard.