Harman SoundCraft Vi3000 - Page 103

Vi3000 USER MANUAL
®
10.2.1 10.2.1: MONITORING > MON SETUP
10.2.1: MONITORING > MON SETUP
Outputs Solo
Assign
Assign individual Output
Solos to Monitor A,
B, and Headphones
outputs.
When selected, an output assignment screen is dis-
played in the master touch screen area. You can select
individual output buss solos for the specic monitor
output. This is useful for stage monitoring applica-
tions where the solos of in-ear monitor mixes could be
programmed to appear only on Monitor B for example,
which could have an in-ear headphone system connect-
ed to it. In this example, conventional wedge monitor
mixes could be programmed to appear only on Monitor
A when soloed, where Monitor A could be connected to a
wedge speaker system.
DIM Level Range Low Range High
Adjust the monitoring
DIM Level between 0
and –innity.
The DIM function is only activated if the Return Talkback
function is activated via the GPIO facility.
-innty 0dB