Vi3000 USER MANUAL
13.1 13.1: EDIT > COPY, PASTE, UNDO
13.1: EDIT > COPY, PASTE, UNDO
• Copy FX
To make selection of the source and destination Lexicon FX units easy, a set of four FX-select encoders appears on
the central screen in both Copy and Paste modes. The selection is made by either touching the relevant encoder or
pressing the corresponding Vistonics button beside the encoder. If the FX unit is assigned to a channel or bus then the
units can be selected by touching the FX block on the channel strip.
Note that only the parameters relating to the currently active FX Type are copied/pasted for each unit. For example, if
LEX1 is is selected, and is currently set to the Small Hall FX type, then only the Small Hall parameters will be copied.
Paste Active
Enter paste mode to
Paste any channels,
processing blocks,
parameters, or Lexicon
FX settings (selected in
Copy mode) to a new
destination.
To paste anything selected in Copy mode, press [Paste]
to enter Paste mode, then select the destination channel
by pressing its [SOLO/SEL] button or touching any VST
eld on the channel. The clipboard content is immedi-
ately copied to each selected channel. Once you have
nished, press the [PASTE] button again to exit Paste
Mode and enter normal operation.
IMPORTANT! Remember to switch PASTE mode off
immediately after use, otherwise accidental pasting
of the clipboard will occur the next time you touch a
screen or press a Solo/Sel.
Paste Mode
Active
Undo Edit
Undo the last paste
operation.
Copy Mode
Active
To Next Page
Loading...
Need help?
General
