4.3: INPUT CHANNEL > DYNAMICS
Vi3000 USER MANUAL
4.3 INPUT CHANNEL > De Esser
Vi3000 USER MANUAL
17.1 17.1: FX > USING THE FX
17.1: FX > USING THE FX
To patch an input channel as an FX return, select that input’s input block from the top of the touch screen channel
strip, then use either the {IN 1 PATCH} or {IN 2 PATCH} option to assign the output of an FX unit to that channel.
Touch the Insert/output/delay block in the channel strip, then use the BUS OUT PATCH or INS PATCH options in the
VST section to bring up the relevant patching options onto the touch screen. Simply select the Lexicon In page from
the options on the right hand side of the touch screen and then select the required FX unit.
If you are patching the output of a stereo aux bus, then left and right buttons will appear in the patch screen. For nor-
mal routing you should assign each to the corresponding inputs of an FX unit.
As An FX Return
To Next Page
Loading...
