Harman SoundCraft Vi3000 - Page 53

Vi3000 USER MANUAL
®
6.5.1 6.5.1: INPUT CHANNEL > INPUT
®
Vi3000 USER MANUAL
6.5.1: INPUT CHANNEL > INPUT
LO CUT Cut-Off
Frequency Field / Group: LO CUT Range Low Range High
Adjusts the LO CUT cut-
off frequency
This is part of the digital (post AD) LO CUT / HIGH CUT
section and affects all inputs. The affected frequency
range is shown graphically in the EQ section of the touch
screen.
20Hz 600Hz
LO CUT IN Field / Group: LO CUT Range Low Range High
Switch the digital LO
CUT lter in and out
When the digital LO CUT lter is switched in, the LO
CUT indicator above the response graph in the EQ touch
section is highlighted in blue.
Out In
HI CUT Cut-Off
Frequency Field / Group: HI CUT Range Low Range High
Adjusts the HI CUT lter
cut-off frequency.
This is part of the digital (post AD) LO CUT / HIGH CUT
section and affects all inputs. The affected frequency
range is shown graphically in the EQ section of the touch
screen.
1kHz 20kHz
HI CUT IN/OUT Field / Group: HI CUT Range Low Range High
Switch the digital HI
CUT lter in and out
When the digital HI CUT lter is switched in, the HI CUT
indicator above the response graph in the EQ section of
the touch screen is highlighted in blue.
OUT IN
Channel Pairing
Selection
Field / Group: PAIR-
ING Inactive Active
Activate channel pairing
selection on touch
screen.
The touch screen will show pairing candidate options for
the channel - these will be consecutive channel numbers
(horizontal neighbours) and the corresponding chan-
nels on higher and lower layers (vertical neighbours).
All channel parameters will be copied to the selected
pairing candidate and the pairing FORMAT eld will be
displayed.
No Selection
Channel
Selection
Pairing Format
Selection
Field / Group: FOR-
MAT Range Low Range High
Adjusts stereo format of
paired channels.
The choices are LR, RL, LL, RR, MONO. If the channel
is not paired, the FORMAT eld will not be displayed.
LR MONO