4.3: INPUT CHANNEL > DYNAMICS
Vi3000 USER MANUAL
4.3 INPUT CHANNEL > De Esser
Vi3000 USER MANUAL
9.3 9.3 MUTE & VCA GRPS > AUX VCA GROUPS
9.3 MUTE & VCA GRPS > AUX VCA GROUPS
Auxilliary VCA Procedure
1) Select the Aux bus required by selecting the required master fader page [A]-[C].
2) Activate the [FLW] key next to the master faders.
3) Press the [SOLO/SEL] key under the required Aux master fader (or use the solo switches in the Master VST area).
4) Press [VCA] (for VCA 1-8) or [E](for VCA 9-16).
5) The FaderGlow for any active VCA master faders will change to white and the faders will move to show the offsets
being applied to the Aux feeds from those channels assigned to the VCAs. At this point, the VCA Master [SOLO/SEL]
keys have no function. The VCA [ON] switch controls the Aux send On/Off on the member channels.
6) To select another Aux for adjustment, press the required bank key [A]-[C], solo the required aux (or solo directly on
the VST screen), and press [VCA] or [E]. To exit, press [SOLO CLEAR] and de-select [FLW].
Note: To set up Auxilliary VCAs, press the MUTE & VCA GROUP [SETUP] button after step 4 and assign member
channels to that Aux VCA group as per the normal VCA group setup procedure (use the channel [SOLO/SEL] buttons
to choose members, then press [SETUP] to exit). Note that Aux VCA Groups have to share the same input assign-
ments as the ‘normal’ channel VCAs.
To Next Page
Loading...
Need help?
General
