Harman Studer D21m - Page 79

Date printed: 24.01.12
63
D21m System
J22:
ES Giga
ES 100
LEDs ES-100 / ES-GIGA Indicate the mode selected with jumper J22.
ES CLOCK Green: The card is the clock source of the EtherSound
®
network.
Red (only in case of a ring network topology): The card was defined to be
the clock source of the EtherSound
®
network, but it is not, due to a device or
cable failure in the ring.
Flashing red (only in case of a ring network topology): The card was not
defined to be the clock source of the EtherSound
®
network, but it actually is,
due to a device or cable failure in the ring located just next to the card.
Dark: The card is not the EtherSound
®
clock source.
DIP Switch SW1 DIP switch for D21m channel count setting:
1 2 3 4 5 6 7 8 Number of Channels
OFF OFF OFF OFF - - - - 0 inputs
OFF OFF OFF ON - - - - 8 inputs
OFF OFF ON OFF - - - - 16 inputs
OFF OFF ON ON - - - - 24 inputs
OFF ON OFF OFF - - - - 32 inputs
OFF ON OFF ON - - - - 40 inputs
OFF ON ON OFF - - - - 48 inputs
OFF ON ON ON - - - - 56 inputs
ON OFF OFF OFF - - - - 64 inputs (factory default)
ON
:
ON
OFF
:
ON
OFF
:
ON
ON
:
ON
-
-
-
-
-
-
-
-
-
-
-
-
NOT ALLOWED
- - - - OFF OFF OFF OFF 0 outputs
- - - - OFF OFF OFF ON 8 outputs
- - - - OFF OFF ON OFF 16 outputs
- - - - OFF OFF ON ON 24 outputs
- - - - OFF ON OFF OFF 32 outputs
- - - - OFF ON OFF ON 40 outputs
- - - - OFF ON ON OFF 48 outputs
- - - - OFF ON ON ON 56 outputs
- - - - ON OFF OFF OFF 64 outputs (factory default)
-
-
-
-
-
-
-
-
-
-
-
-
ON
:
ON
OFF
:
ON
OFF
:
ON
ON
:
ON
NOT ALLOWED