28
Dry Seasoned Wood Only! Save These InstructionsHarman®  •  TL300 Owner's Manual_R25  •  2007 -___  •  08/15
B. General Maintenance Procedures
Ash Removal
•  Frequency: As needed / Every day or two
•  By: User
Wear Leather Gloves To Prevent Skin Burns!
Open the ash removal door by lifting upward on the latch 
handle, then swing the door open. Pull the ash pan out of 
therebox,usingtheliponthefrontofthepan.Oncethe
ashpanisremovedfromthestove,youcanipthecarry
handle up for convenience.
Ifremovingasheswhileareisburning,closeandlatchthe
ash door while disposing of the ashes.
DO NOT leave the appliance unattended with the ash door 
open.
Door Glass
•  Frequency: As needed / Weekly
•  By: User
Whenever the view of the re is obstructed, or weekly,
clean the glass using a soft cloth dampened with standard 
household glass cleaner.
DISPOSAL OF ASHES;
Ashes should be placed in a steel container with 
a tight fitting lid. The container of ashes should 
be moved outdoors immediately, and placed on a 
noncombustible  oor  or  the  ground,  well  away  from 
all combustible materials, pending nal disposal. If the 
ashes are disposed of by burial in soil or otherwise 
locally dispersed, they should be retained in the closed 
container until all cinders have completely cooled. Other 
waste shall not be placed in this container.
Glass Retainer 
screws
Glass Panel
Glass Gasket
Glass Retainers
Door Frame
Glass Specications: 5mm X 419mm X 314mm arched.
CAUTION
DO NOT CLEAN GLASS WHEN HOT. Allow glass to 
cool before cleaning.
Fly-ash allowed to accumulate on the glass may lead to 
permanent fogging or "crazing" of the glass. 
Inspect the glass and sealing gasket. Replace gasket as 
needed. Do not operate the stove with a broken glass. 
Replacement glass, which is ceramic glass, should be 
obtained only through your Harman dealer.
Toreplaceabrokenglass;rstbesuretocarefullyremove
the broken glass and any remaining shards or pieces. With 
the door laying on a at surface, lay the gasketed glass
panelontothedoorandbesureitisproperlyttedintothe
channel. Lay the glass retainer clips in place near each 
corner, and secure them using the 3/8" screws. Be sure to 
tighten each screw equally so you don't create a pressure 
point on the glass.
Do NOT Use Substitute Material for Glass Replacement.
NEVER USE ABRASIVE MATERIALS ON THE GLASS.
WARNING
DO NOT ABUSE GLASS BY STRIKING OR SLAMMING 
THE DOOR CLOSED. THIS TYPE OF BREAKAGE IS 
NOT COVERED BY THE PRODUCT WARRANTY.