Harman VP4 ROW User Manual

Uconnect™ ACCESS USER’S MANUAL 77
terminated and if there is a call on hold, it will become
Place/Retrieve A Call From Hold
During an active call, touch the “Hold” soft-key on the
Phone main screen.
Toggling Between Calls
If two calls are in progress (one active and one on hold),
touch the “Swap” soft-key on the Phone main screen.
Only one call can be placed on hold at a time.
You can also press the button to toggle between the
active and held phone call.
Join Calls
When two calls are in progress (one active and one on
hold), touch the “Join Calls” soft-key on the Phone main
screen to combine all calls into a Conference Call.
Call T ermination
To end a call in progress, momentarily press the but-
ton or the end soft-key. Only the active call(s) will be
the new active call. If the active call is terminated by the
1
far end, a call on hold may not become active automati-
cally. This is cell phone-dependent.
Redial
• Press the “Redial” soft-key,
• or press the and after the “Listening” prompt and
the following beep, say “Redial”,
• After the “Listening” prompt and the following beep,
say “Redial”,
• The Uconnect™ Phone will call the last number that
was dialed from your mobile phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect™ Phone after the vehicle ignition key has been
switched to OFF.

Harman VP4 ROW Specifications

General

Brand	Harman
Model	VP4 ROW
Category	Car Receiver
Language	English