Harman XXV - Automatic Start Up; Starting Fire Procedures

Harman® •  Owners anualR2 • 200 - • 0812 0 3 -9 0 -0 0 6 8 4 c
Monthly Cleaning- continued:
Clean the heat exchanger with scraper as shown in igure
5.. Brush or scrape the inside of the stove to remove y ash.
Remove the ash pan and dispose of ashes in an approved
manner, according to local codes.
The exhaust passage may need cleaned as well. eep
in mind the ESP Sensor is located ust inside the exhaust
passage igure 5.7. Be sure not to damage the ESP Sensor
while cleaning this area.
Remove the combustion blower by loosening the  wing nuts
(igure 5.5), twisting the combustion blower mount plate
counterclockwise to unlock, and pulling the blower out.
Clean the combustion blower housing and fan blade with a
brush and a vacuum cleaner igure 5..
Note: o not use a household vacuum to clean the stove. We
recommend that you use a shop vacuum that is equipped with
a ne dust lter called a HEPA lter or a vacuum specially
made for y ash and soot. USING A ACUU WHICH IS
NOT EUIPPE WITH A INE UST ILTER WILL BLOW
LY ASH AN SOOT OUT INTO THE ROO.
NOTE: THE STOE UST BE COPLETELY OUT BEORE
YOU ACUU THE STOE. LIE PELLET EBERS, I
SUCE INTO THE ACUU, WILL LIGHT THE ACUU
ON IRE AN AY ULTIATELY CAUSE A HOUSE IRE.
Use a brush to clean the ue, being careful not to damage
the ESP probe igure 5.7.
Reinstall the combustion blower by turning plate clockwise
to lock into place and tightening the  wing nuts. Be sure
the fan plate is ush with the exhaust housing on the stove
body and the motor armature points up toward the hopper.
Slide ash pan into the stove and latch the door.
F igure 5 .4
F . Combustion Blower Chamber
Scrape heat
exchanger
with arrow
scraper tool.
F igure 5 .5
Loosen
() thumb
screws.
F igure 5 .6
Clean these areas with brush
and vacuum
F igure 5 .7
ESP Probe
Be careful not
to damage ESP
probe when
cleaning with
brush.