harmoni 25 User Manual

harmoni 25
9
Change the oor temperature max. limit (mode 3 & 5)
Make sure the thermostat is turned off.
Hold the
button for 10 seconds until the display shows
Release the button and the display will show SET
Enter the maximum oor temperature (range 20°C–45°C).
4.5 Reading the oor temperature (mode 3 & 5 only)
Make sure thermostat is turned on.
Press
once, the FT will ash, and the display will show
the oor temperature.
In mode 2 (oor sensor) the display always shows the current
oor temperature.
In modes 1 & 4 (room sensor) the display always shows the
current room temperature.
4.6 Frost protection mode
To enable frost protection mode, turn off the thermostat.
Press
for 3 seconds.
Select 01 (00 = disabled).
When frost protection has been enabled the display shows
When enabled and the thermostat is turned off, heating will
activate if the room/oor temperature is lower than 5°C; heating
will stop if the room/oor temperature is higher than 7°C.

harmoni 25 Specifications

General

Brand	harmoni
Model	25
Category	Thermostat
Language	English