© 2010 Harmonic Inc. 1 ProView 7000, v.2.3, Rev. A
ProView 7000™
Integrated Receiver and Stream Processor
Quick Setup Guide
Introduction
Thank you for choosing the ProView 7000 Integrated Receiver and Stream Processor.
This document provides step-by-step instructions for quick initial setup of the ProView 7000
using the unit’s front panel interface and its Element Management Software (EMS) graphical
user interface.
For detailed information on operation and configuration of the ProView 7000 platform, refer
to the ProView 7000™ Integrated Receiver and Stream Processor User Manual (Harmonic
Manual Part No. MAN-PVR-7K-2.3).
Installation and Cable Connection
Mechanical and Electrical Installation
For information about mounting, installation, electrical connection and safety precautions
refer to Chapter 2 in the ProView 7000 User Manual.
Cable Connections
All ProView 7000 connectors are located on the rear panel. Connect data, control and power
cables as required for the specific application. Connect a monitor to the unit.
To Next Page
