1. Place booster seat rmly against the back of a
forward-facing vehicle seat. The vehicle seat MUST
be equipped with a 3-point lap-and-shoulder belt.
Booster must be level, stable and not rock side-to-
side (see “Vehicle seang posions”).
2. Place child in the booster seat with
child’s back at against the back of
the booster seat.
3. Adjust headrest height so that
the boom of the headrest is
EVEN with the top of the child’s
shoulders. See secon “Headrest
height adjustment”.
4. Thread shoulder belt poron of
the 3-point lap-and-shoulder belt
system through the shoulder belt
guide ❶ and ensure that shoulder
belt lies across child’s shoulder
and chest, and NOT across child’s
face or neck.
5.
❷
6. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
! Any straps holding the restraint to the vehicle should
be ght, any straps restraining the child should be
adjusted to the child’s body, and the straps should not
be twisted.
❶
❷
20